Maintenance - Husqvarna K 7000 Ring Manuel D'utilisation

• Push the machine stop button on the power pack.
Refer to the operator's manual for the power pack.
Lamp indicators in the product
Indication
1 green lamp flashes. The product is connected to a power pack and is pre-
2 green lamps flash.
3 green lamps flash.
3 green and 1 yellow
lamps flash.
3 green, 1 yellow and
1 red lamps flash.
All the status indica-
tion lamps flash.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
20
Cause
pared for operation.
The power output is less than 70% of the maximum
available output in operation.
The power output is 70-90 % of the maximum available
output in operation.
The cutting speed is at its best performance.
The power output is 90 % of the maximum available out-
put in operation.
The power output drops.
The product is too hot.
The product is too hot.
The power is decreased.
The system is in automatic shutdown.

Maintenance

Step
N/A
N/A
N/A
Decrease the load.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
Increase the water flow or airflow
to decrease the temperature.
Put the power pack in a location
with lower temperature.
Refer to the operator's manual
for the power pack for more in-
structions.
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
1461 - 001 - 17.02.2020