Maintenance - Husqvarna FS7000 D Manuel D'utilisation

• Push the left and right E-track adjustment buttons
(A) to adjust the rear axle. Push again and again for
small adjustments.
A B
12
10 14
8 18
V
Note: The E-track gauge (C) on the display shows
the current angle of the rear axle. The adjustment is
saved when the ignition is off or if the product
becomes without power.
• Look at the movement and the direction of the
product to make sure that the adjustment is correct.
• To reset the rear axle to the center angle that is set
in the system, push the E-track reset button (B).
• To go back to the adjusted angle, push the E-track
reset button again.
• To adjust the center angle that is set in the system,
refer to the operator's manual for the control panel.
To adjust the rear axle manually
• Turn the adjustment bolt at the lower left at the rear
of the product. Use an 18 mm wrench.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
28
C
0
2
1 3
0 4
< 1200 RPM
180
150 210
5.0
WORKING HOURS 110 250
˚F
CURRENT: STOP:

Maintenance

a) If the product steers to the right during operation,
turn the adjustment bolt counterclockwise.
b) If the product steers to the left during operation,
turn the adjustment bolt clockwise.
A
To stop the product
1. Turn the knob for the throttle control to the low idle
position.
2. Close the water valve.
3. Let the engine operate at idle speed for 2-3 minutes.
4. Turn the engine start switch to the stop position (A).
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
WARNING: The cutting blade continues to
rotate for a while after the engine stops. Do
not stop the cutting blade with your hands.
Serious injuries can occur.
1223 - 002 - 09.07.2019
A