tau K580M Notice D'utilisation page 15

CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control
devices;
2_ LED DL8 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL8 turns off for approx. 3 seconds and then remains steady to indicate that the code
has been cancelled;
5_ repeat the procedure from point 1 using button P2 to cancel all the associated radio control
devices;
6_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
ATTENTION: TO memorise a code on a new type of remote control unit (e.g.: from dip-
switch to rolling code or vice-versa) both channels must be cancelled.
1- The automation does not start
a- Check there is 230Vac power supply with the multimeter;
b- Check that the N.C. contacts on the card really are normally closed (5 green LEDs illumi-
nated) and that the red opening command LEDs are turned off;
c- Check that the red LED DL8 is steadily illuminated;
d- Set dip 6 (phototest) to OFF;
e- Check that the fuses are intact with the multimeter.
2- The radio control has very little range
a- Check that the ground and the aerial signal connections have not been inverted;
b- Do not make joints to increase the length of the aerial wire;
c- Do not install the aerial in a low position or behind walls or pillars;
d- Check the state of the radio control batteries.
3- The gate opens the wrong way
a_ Invert the position of dip-switch No. 10 after having turned off the power to the control
unit.
MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
K580M 15