Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Backer Panels
NOTES:
Dashed lines represent backer panel placement.
Illustration shows backer panels placed on decorative
overlays.
³⁄₁₆
6
"
(15.7 cm)
Top Offset
⁵⁄₈
1
" (4.13 cm)
22"
(55.9 cm)
A
¹⁄₂
70
"
(179.1 cm)
¹⁄₄
33
"
(84.5 cm)
A
A
Bottom Offset
¹⁄₈
" (3.2 mm)
Model
A
42
16³/₄" (42.55 cm) 22³/₄" (57.79 cm)
48
19¹/₄" (48.90 cm) 26¹/₄" (66.68 cm)
14
C
Side Offset
¹⁄₂
" (12.7 mm)
Bottom Offset
¹⁄₂
" (1.27 cm)
Handle-
Side Offset
¹⁄₄
"
(6.4 mm)
¹⁄₂
70
"
(179.1 cm)
B
Bottom Offset
¹⁄₈
" (3.2 mm)
B
C
39³/₄" (100.97 cm)
45³/₄" (116.21 cm)
Dispenser Frame (dispenser models only)
The dispenser frame attaches to the panel with 4 screws.
C
A. Decorative panel
B. Refrigerator door
C. Dispenser frame
The dispenser frame overlaps the dispenser cutout by ⁵⁄₁₆"
(0.78 cm) on each side and ¹⁄₂" (1.27 cm) on the top and bottom.
A
A. ¹⁄₂ " (1.27 cm) Overlap
Euro-Style and Pro-Style
Custom Side Panels
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
may not reflect the needed panel installation dimensions.
The side panel should be a minimum of ½" (1.27 cm) thick
to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
A
B
A
®
Publicité
Table des Matières
