Changing Saw Blades; Putting Into Operation - Bosch GFZ 14-35 A Instructions D'emploi

Connecting the Dust Extractor
6
Hook on the channel for dust extraction 6 at the rear
under the handle and latch onto the catches 8 . Insert
the vacuum hose (35 mm dia.) directly into the cou-
pling of the channel.

Putting into Operation

Always use the correct supply voltage!
The voltage of the power source must agree with the
value given on the nameplate of the machine. Ma-
chines designated for 230 V can also be operated with
220 V.
When switching on, the saw blades must not be
resting against, come in contact with or strike
anything!
Switching On/Off
Switching on:
Press the switch-on lock 4 to the left or right and hold,
then press the on-off switch 5 .
Switching off:
Release the on-off switch 5 .
Lay the machine down only after the saw blades have
come to a standstill.
After switching off, do not brake the saw blade to a
stop by applying side pressure.
Regulating the Stroke Rate (GFZ 16-35 AC)
The stroke rate can be continuously adjusted with the
stroke rate regulator 3.
Setting 1:
Setting 6:
The Constant Electronics maintain the selected stroke
rate between no-load and load nearly constant. In this
manner, uniform and clean cuts are possible also in
materials of different compositions.
3 609 929 347 • (00.12) T
8
Lowest stroke rate
Highest stroke rate
English–3

Changing Saw Blades

For protection against injury from
the sharp cutting edges, wear pro-
tective gloves when mounting as
well as when checking the saw
blades.
Place the machine on the loop handle.
Spread the channel for dust extraction 6 at the cat-
ches 8 and remove to the rear.
Note: The saw blades (engaging pins) stop at a differ-
ent position each time the machine comes to a stand-
still. The illustrations show an arbitrary position.
Removing the Saw Blades
Press the SDS release button 7. This unlocks the saw
blades.
Swing both saw blades upward at the same time and
out of the engaging pins
Slide the saw blades apart
other, pull out of the saw blades guide 11
When attempting to remove at the same time, the
noses of the saw blades block each other.
7
G .
H and, one after the
I .
11