Measuring - IEM Tel-O-Graph GSM Mode D'emploi

Measuring blood pressure and pulse

Measuring

WARNING
Risk of injuries during measurement!
Do not place the air hose around your neck.
▪
▪ If you feel any pain during the measurement, stop the measurement.
Do not place the blood pressure cuff over wounds.
▪
1. Apply the blood pressure cuff and assume the correct posture.
2. Press the
The display shows the start screen(Fig. 6).

3. Press the
The blood pressure monitor will confirm this with a short acoustic signal and briefly displays the display

functions. The blood pressure cuff slowly pumps up. The fitting pressure is displayed on the display. After
the initial pumping, there is additional pumping. Once the blood pressure monitor detects a pulse, the icon
appears. The reading is taken as the air is let out. The blood pressure monitor confirms the end of the
measuring with a short acoustic signal.
Note
Do not talk during the measurement. You can stop the measurement at any time by pressing the
button.
30
button.
button again to start the measurement.