Options; Installing/Adjusting The Lumbar Support; Plug Inserts; Adhesive Pads - Invacare Matrx MX1 Manuel D'utilisation

6 Options

6.1

Installing/Adjusting the Lumbar Support

 The Lumbar Support is a pre-fabricated foam insert that
provides lower back support for additional comfort. The
position of the lumbar insert can be adjusted inside the
Invacare Matrx MX1 cover, or it may be removed if no
lumbar support is desired
1. To access the lumbar support, open the hook and loop fastening strips
on the outer cover A at the bottom rear of the back shell.
2. The foam lumbar support B is installed inside the Invacare Matrx
MX1 cover between the foam back cushion C and the back shell D.
3. The lumbar support can be adjusted to any desired height/position.
4. Refasten the cover onto the back pan.
A
Part No. 1176090
D
B
C
6.2

Plug Inserts

Optional plug inserts (Model DP-250) A may be used to fill unused
mounting holes B on the back shell C.
A
6.3

Adhesive Pads

Adhesive pads A are available to protect the back shell B from
scratches.
1. Peel the protective paper off of the back of the adhesive pad.
2. Install the adhesive pad between the back shell and the back cane C
or other wheelchair component that may rub against the back shell.
A
25
6 OPTIONS
C
B
A
C
B
Invacare® Matrx® MX1