Adjusting The Back Angle And Back Depth; After Installation; Removing The Back Cushion - Invacare Matrx MX1 Manuel D'utilisation

5 QUICK RELEASE DUAL MOUNT

5.11 Adjusting the Back Angle and Back Depth

1. Loosen the screws A in the mounting pin assembly of both clamp
bodies B.
2. Adjust the position of the mounting pin assembly via the slots in the
clamp bodies to achieve the desired back depth (Detail A) and back
angle (Detail B).
 Angle and depth adjustments must be made equally on
both sides.
3. Tighten the screws on both clamp bodies to secure the back into
position.
Detail A
B
A
A
Invacare® Matrx® MX1

5.12 After Installation

1.
2.

5.13 Removing the Back Cushion

1.
2.
Detail B
24
Verify that all mounting hardware is fully tightened.
Ensure that the back is securely attached to the wheelchair.
Unlock the levers on the adjustable mounting brackets.
Lift the back cushion up and forward to disengage it from the
mounting pins.
1
2
Part No. 1176090