Standard Installation - Invacare Matrx MX1 Manuel D'utilisation

3 MONO MOUNT
 The pins should slide into position with little effort. If the
pins are difficult to insert, verify that the band clamp is
properly centered and fully seated inside the slots of the
rigidizer bracket.
B
4
5
D
E
F
3
OPTIONAL INVERTED POSITION
FOR 9" (23 CM) TALL BACKS
E 3
D
B
Invacare® Matrx® MX1
STANDARD
INSTALLATION
8
G
F
G
10. Center the bracket between the back canes.
11. Tighten the compression bar hardware A just snug enough to hold
the bracket assembly in place.
WARNING
DO NOT adjust the center screw in the rigidizer
bracket. The center screw B is designed only to hold
the compression bar in place during installation.
Adjusting this screw may prevent the compression bar
from tightening properly onto the back cane.
 Do not fully tighten the compression bar at this time.
12. Install the tracking plate. Refer to Installing the Tracking Plate on
the Back Shell on page 11.
11
A
10
B
A
Part No. 1176090