Installing The Band Clamps; Installing The Back - Invacare Matrx MX1 Manuel D'utilisation

4 FIXED DUAL MOUNT
4.6

Installing the Band Clamps

1. Install the two band clamps A onto the back canes B of the
wheelchair.

Allow the band clamps to rest on the rigidizer bar C.
4.7

Installing the Back

1. Align and insert the tabs A on the band clamp B with the slots C
in the clamp body D.
2. Ensure the band clamp is fully inserted into the clamp body.
D
A
C
Invacare® Matrx® MX1
B
C
A
B
3. Loosen the compression bar hardware E, so the clamp body rests
flush against the back cane.
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw F is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
4. Insert the two locking pins G into the clamp body to lock the band
clamp in position.
 The pins should slide into position with little effort. If the
pins are difficult to insert, verify that the band clamp is
properly centered and fully seated inside the slots G of
the clamp body.
5. Ensure both locking pins are fully inserted.
\
E
16
H
G
F
Part No. 1176090