Securing The Clamp Body To The Band Clamp; Securing The Clamp Body Assembly To The Back Cane - Invacare Matrx MX1 Manuel D'utilisation

5.7

Securing the Clamp Body to the Band Clamp

1. Insert the two locking pins A into the clamp body B to secure it to
the band clamp C.
 The pins should slide into position with little effort. If pins
are difficult to insert, verify that the band clamp is properly
centered and fully inserted inside the slots of the mounting
bracket.
2. Ensure the pins are fully seated into the clamp body.
3. Repeat STEPS 1-2 for the opposite side.
B
5.8 Securing the Clamp Body Assembly to the Back
Cane
1. Slide the clamp body assembly A to the desired height on the back
cane B (Detail A).
2. Hold the clamp body assembly perpendicular to the back of the
wheelchair (parallel to the rear wheel).
Part No. 1176090
C
A
21
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw C is designed only to hold the
compression bar in place during installation (Detail B).
Adjusting this screw may prevent the compression bar
from tightening properly onto the back cane.
3. Tighten the two screws D to push the compression bar E against
the back cane and secure the clamp body in place.
 When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
4. Repeat STEPS 1-3 for the opposite clamp body assembly.
 The clamp bodies must be at the same height on each side
of the back cane. Otherwise the back may not install
correctly or at all.
DETAIL A
B
A
5 QUICK RELEASE DUAL MOUNT
DETAIL B
D
C
Invacare® Matrx® MX1
E