Locking Pin, Wheel-Wheel Motors - Husqvarna PG 820 RC Manuel D'utilisation

• Start the grinding unit by turning the STOP/RUN
switch on the remote control to RUN. The grinding unit
will then start smoothly and accelerate to the set
speed within 5 seconds.
• Depress the machine stop. Check that the grinding
unit stops after approximately 2.5 seconds.
• Reset the machine stop by turning it clockwise.
• To restart the machine, turn STOP/RUN to STOP.
Then press the 'Back' button to return to the drive
screen.
NOTICE! The same procedure as for 'Machine stop' is
used to restart the machine when the emergency stop
has been activated while the machine is on remote
control.
Turn STOP/RUN to the STOP position. Then press the
'Back' button to return to the drive screen.

Locking pin, wheel-wheel motors

Locking pins on the wheels are used to lock them to the
motors for operating the machine remotely
MACHINE´S SAFETY EQUIPMENT
Checking the locking pins
• Make sure the locking pins on the wheel to the wheel
motors are depressed (locked position). It should be
difficult to push the machine forward.
Tip: Pull out the locking pins and push the machine
forward. Depress the locking pins and push the machine
forward, feel the difference in how hard it is to push it
forward.
–
English 11