Device Description; Delivery, Unpacking And Accessories - SIKA InduQ VMI Série Notice D'utilisation

Device description

1 Device description
®
induQ
The of the VMI series from SIKA is a flow sensor without moving parts. The meas-
urement is performed using magnetic induction.
The VMI is used for measuring or metering water and electrically conductive fluids. The com-
pact design and independence from the intake and discharge sections allows the VMI to be
used under a variety of conditions.
Versions:
The VMI is available in nominal sizes DN 2, DN 7, DN 10 and DN 20.
Type plate:
The type plate sticker is located on the bottom side of the VMI.
It contains the most important data, the connection diagram and the arrow for the flow direc-
tion.

1.1 Delivery, unpacking and accessories

All units have been carefully checked for their operational reliability before shipment.
 Immediately after receipt, please check the outer packaging for damages or any signs of
improper handling.
 Report any possible damages to the forwarder and your responsible sales representa-
tive. In such a case, state a description of the defect, the type and the serial number of
the device.
Report any in-transit damage immediately. Damage reported at a later date shall not be
recognized.
Unpacking:
 Carefully unpack the unit to prevent any damage.
 Check the completeness of the delivery based on the delivery note.
Scope of delivery:
 1x VMI as ordered.
 1x Operating manual.
IMPORTANT!
 Use the type plate to check if the delivered unit corresponds to your order.
 In particular, for devices with electrical components, check to see if the correct power
supply voltage is specified.
- 24 -
®
induQ
— Series VMI
© SIKA • Ba_VMI • 10/2019