Display Setup - NEC MultiSync LCD2070NX Manuel De L'utilisateur

To attach the MultiSync
. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output : Connect the DVI signal cable to
the connector of the display card in your system (Figure ). Tighten
all screws.
For the PC with Analog output: Connect the 5-pin mini D-SUB signal
cable to the connector of the display card in your system (Figure 2).
Tighten all screws.
For MAC setup: Connect the Macintosh cable adapter to the computer,
then attach the 5-pin mini D-SUB signal cable to the Macintosh
cable adapter (Figure 3). Tighten all screws.
NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC
Display Solutions of America, Inc. at (800) 632-4662.
Figure 
DVI Signal Cable
LCD monitor to your system:
®
Figure 3
Macintosh Cable Adapter
(not included)
Note: Some Macintosh systems do not
require a Macintosh Cable Adapter
3

Display Setup

Figure 2