Setup Procedure - NEC LCD3000 Manuel Utilisateur

Setup Procedure

1. Determine the installation location
CAUTION: DO NOT ATTEMPT TO INSTALL THE LCD
MONITOR BY YOURSELF
Installing your LCD display must be done by a qualified
technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD
MONITOR MUST BE DONE BY TWO OR
MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD
monitor falls.
IMPORTANT: Lay the protective sheet, which was wrapped
around the LCD monitor when it was
packaged, beneath the LCD monitor so as not
to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AA batteries. To
install or replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–)
indications inside the case.
3. Replace the cover.
Remove the cover Insert the batteries
CAUTION: Incorrect use of batteries can result in leaks
or bursting.
Be careful especially about the following points.
• Place "AA" size batteries matching the + and - signs on
each battery to the + and - signs of the battery
compartment.
• Don't mix battery types.
• Don't combine new batteries with used ones.
It causes shorter battery life or leakage of batteries.
• Remove dead batteries immediately to prevent battery
liquid from leaking into the battery compartment.
Don't touch leaked liquid, it causes damages to your
skin.
NOTE: If you do not intend to use the Remote Control for
a long period, remove the batteries.
01_English 6
All manuals and user guides at all-guides.com
3. Connect external equipment
•
•
4. Connect the supplied power cord
•
•
5. Switch on the power of all attached
When connected with a computer, switch on the power of
the computer first.
6. Adjust the sound
Make adjustments when adjustment of the volume is
required.
7. Adjust the screen (See pages 18~26)
Make adjustments when adjustment of the screen display
position or distortion is required.
Replace the cover
8. Adjust the image (See pages 18~26)
Make adjustments when picture adjustment such as the
brightness or contrast is required.
9. In case of portrait position
•
•
English-6
(See pages 9~15)
To protect the connected equipment, turn off the main
power before making connections.
Refer to your equipment user manual.
The power outlet socket should be installed as near to
the equipment as possible, and should be easily
accessible.
Fully insert the prongs into the power outlet socket.
Loose connection may cause noise.
external equipment
Remove the stand.
Left side of monitor must become upper side (seen from
front).
15/10/02, 12:07 pm