Publicité
Les langues disponibles
Les langues disponibles
Important safety InstructIons
read before proceedIng further.
retain for future use.
WarnIng
Installation work and electrical wiring must be done by qualified electrician(s) in accordance
with all federal, state and local laws and applicable codes and standards, including fire-rated
construction.
filter change should be carried out by a qualified electrician.
WarnIng
risk of electric shock! If casing is removed or handled improperly the internal components of the
unit may cause harm or become permanently damaged.
to reduce the rIsK of fIre, eLectrIc shocK, or InJury to persons,
obserVe the foLLoWIng:
before InstaLLatIon
Before beginning any installation work you must confirm the following.
WIrIng
Check that the electrical supply corresponds to that shown on the rating plate.
The unit requires a 15 amp circuit breaker with a dedicated line and neutral.
The unit must be grounded properly.
When connecting the unit to the electricity supply use electrical wiring in accordance with all federal,
state and local laws and applicable codes and standards, including fire-rated construction.
Ensure that the conduit and wires are long enough to connect to the backplate and the terminal block.
safety
Isolate the power before installation or service.
InstaLLatIon
Make sure that the unit is installed in compliance with all building codes and/or regulations.
The unit must be mounted on a flat vertical wall capable of supporting the full weight of the unit.
Use hardware as specified in this installation guide.
Ensure no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind
the drilling/mounting area.
If you are installing this hand dryer in a food handling or food manufacturing environment, please
contact the Dyson Helpline for the specialist installation guide that supports this.
Dyson recommends the use of protective clothing, eyeware and materials when installing/repairing as
necessary.
To avoid damage to the fascia surface during installation, store the fascia in the original pacakaging
until it is needed.
LocatIon
The unit is designed for dry, internal location only.
Consult local and national accessibility codes and regulations for relevant installation guidelines.
Conformity and compliance is the responsibility of the installer.
Ensure the required electrical supply is available for later connection.
If the unit is to be installed in a location subject to ADA regulations the installer should verify with their
local governing entity to ensure that the unit is installed to ADA guidelines.
If you are installing this hand dryer in a food handling or food manufacturing environment, please
contact the Dyson Helpline for the specialist installation guide that supports this.
Important
Please refer to the Dyson Operating Manual for details of the guarantee.
do not use any JetWash eQuIpment for cLeanIng on or near thIs
unIt.
2
Publicité
