Dyson AB 06 Guide D'installation page 5

3
Mount bracket to wall.
Secure the bracket to the wall using the
appropriate hardware for the wall type and the
weight of the main unit. Ensure the bracket is
level.
4
Secure backplate to wall.
1. Hook the backplate onto the wall bracket. Use
the backplate to mark the locations for the
four fixing points. Remove the backplate from
the bracket and drill the four holes.
NOTE: For easier access to the lower fixing
screw, temporarily remove the filter.
CAUTION: Do not use the backplate
as a guide when drilling.
2. Hook the backplate onto the wall bracket.
3. Install the electrical wiring via the electrical
entry point.
4. Ensure the electrical wiring sits in the
pre-formed channel in the exterior of the
backplate.
5. Secure the backplate to the wall using
the appropriate hardware.
5
Connect to terminal.
L N
WARNING: Risk of electric shock!
1. Secure the Line, Ground and Neutral wires into
the correct terminal block locations as indicated
on the terminal block casing.
2. Verify the connections are correct before
proceeding.
3. If entry is from the left-hand point in the
backplate, ensure the electrical wiring is
secured in front of the duct with the electrical
wiring clip.
5
6
Attach fascia.
1. Carefully replace the fascia as illustrated.
2. Do not trap the electrical wiring when
attaching the fascia.
3. Make sure that the fascia is mounted
flush before tightening the screws.
4. Insert the (4) anti-tamper screws into the fascia
as illustrated – top screws first, hand-tight,
followed by the lower screws. Then secure
all screws.
5. Test the unit for correct operation.
NOTE: Do not use sealant when fixing
the unit to the wall.