Changing The Filter; Problem Solving - DeguDent Multivac eco Mode D'emploi

3.2 Changing the filter

Filter changing becomes necessary when the amount of time taken when evacuating or flooding the
flask becomes noticably longer than usual.
• Carefully remove the sealing ring from the coupling with a screwdriver.
• Pull out the filter element.
• Remove any remnants of material from the coupling.
• Set the filter on top of the sealing ring.
• Replace the filter along with the sealing ring back into the coupling. The sealing ring must audibly
click into place.
! Operating this unit without a filter can seriously damage the machine and is not to be
undertaken at any circumstance.

4 Problem solving

When turning on the unit or starting mixing, the fuses blow.
The fuse section is located next to the mains socket. Repeated fuse cut out points to a more serious
problem within the machine which should be dealt with by service technicians. Cut outs which occur
once only could have been caused when the stirring motor is blocked. In this case, the blockage
should be removed and the fuse replaced, after which the unit can be started up once more.
!
Before attempting to change a blown fuse,
the unit must be disconnected from the mains.
17