Led For Workspace Illumination; Scope Of Application; Battery And Charging Unit Instructions - hawa Powerlec Vario Manuel D'utilisation

6.3 LED for workspace illumination

By default, the lighting is turned on for 15 sec.
The lighting can be switched off as follows:
1. Remove the battery
2. Press and hold control switch (item 7)
3. Insert battery
4. Release control switch
Switch on again:
1. Remove the battery
2. Insert battery again (without pressing the control switch (item 7))

6.4 Scope of application

With the electro-hydraulic punch tool type Powerlec Vario various shapes can be punched with a number of different punching inserts.
In addition to steel, stainless steel (V2A and V4A) and aluminium sheets, fiberglass and some plastics can also be processed under favourable
conditions. Prelimanary test attempts are advised in these cases.
The following table reflects the limits of the punched hole sizes:
Material Sheet metal thickness
St 37 2,5 mm
Stainless steel (V2A) 2,0 mm
Combinations not reflected in this table, where doubts exsists about the punching ability, we recommend that you consult with us first.
Caution: Only within the intended use may approved materials be punched.
Should other materials be punched, it is mandatory that you consult with the factory first.
Before commencing work, a stress-free condition of the metal sheet must be ensured.

6.5 Battery and charging unit instructions

In addition to the Accu Flexi-power original instructions, instructions for the quick charger is included in the delivery of this device.
It contains important safety and operating instructions which is imperative to read before commencing.
Ill. 2
Short description of the charging process
The charger is equipped for AC 230V with a frequency of 50 Hz.
New batteries should be recharged before initial use.
1. Plug the power cord of the charger into the mains. The charge control light will flash green repeatedly.
2. Align the battery on the charger through the slide quide till the stopper. The terminal cover of the charger opens through the insertion of batteries
and closes when the battery is pulled out.
3. When a battery is inserted, the red charging indicator lights up, the charging process begins with a preset short tone (beep).
4. When charging is completed, the charge control light switches from red to green, and a tone (beep) is made to report the completion of the char
ging process.
5. The charging time varies depending on the temperature (10 ° C - 40 ° C) at which the battery is charging, and the battery condition (e.g. new or if
the battery has been unused for an extended time).
6. Once loaded, remove the battery from the charger and unplug the charger from the mains.
Type
Round holes up to Ø 80 mm
Square holes up to 68 mm x 68 mm
Rectangular punch up to 115 mm diagonal
Round holes up to Ø 80 mm
Square holes up to 68 mm x 68 mm
Rectangular punch up to 115 mm diagonal
10 - 40°C
Ill. 3
(BL1815)
15 min.
(BL1830)
22 min.
Li-ion
17