Eschenbach QUUICKLOOK ZOOM Mode D'emploi page 15

The Quicklook Zoom is powered on by rotating the camera to either
of its operating positions. It is powered off by rotating the camera
back to the closed position.
Reading
Rotate the camera ninety
degrees to its first click position
so that the camera is looking
downwards. Place the unit on
or slightly above the item you
wish to read. You will have to
position the camera directly
over the area of interest. In this
respect Quicklook Zoom differs
from a magnifying glass in that
the image you see does not
correspond to the area directly beneath.
Quicklook Zoom can be operated and viewed from any orientation,
but to obtain the most accurate colour reproduction you should
ideally look directly down on the screen.
Changing image mode
Pressing the Mode button (refer to the diagram on page 14) on the
side of the unit will cycle through the five image modes:
Colour For general viewing
Negative Enhanced reading mode
Positive Enhanced reading mode
Semi-colour Enhanced reading mode with false colours.
Inverted Enhanced reading mode with false colours reversed
When using Quicklook Zoom on different material, experiment with
the different modes to see which helps you to see best.
Note that all original colour is removed from the image in the
enhanced modes.
The colour options used in the semi-colour modes can be selected.
Refer to the "Reading Mode Menu" later in this manual.
Freezing the image
To freeze the image, simply press and hold the Freeze/Brightness
- 15 -