CERTIFIED 060-0581-2 Guide D'utilisation page 18

4. Remove the old paddle from the housing
(Fig. 12).
5. To install the new paddle, place the washer
(A) back onto the bolt (removed in step
1) and insert the bolt so that it protrudes
slightly into the housing of the unit. Thread
the nut and then the other washer (B) onto
the bolt. Fit the new paddles onto the end
of bolt and tighten the bolt (Fig. 13).
6. Reinstall the big pulley plate and align it
with the other end of the paddles. After
fitting the paddles into position, secure the
big pulley plate with the three (3) screws
(Fig. 14).
NOTE: The housing will flex to allow for
installation of the new paddle.
Bolt
Washer (A)
Nut
Washer (B)
18
Fig. 12
Fig. 13
Fig. 14