Electrolux thermaline S90 Instructions D'installation Et D'emploi page 8

1.5 AFTER-SALES SERVICE AND REPAIR
In the event of a permanent fault which inter-
feres with operation, the appliance must be
switched off and disconnected from the
power supply.
To perform maintenance and repairs contact
the factory, the factory representative or a
local service company.
Repair, maintenance work and other adjust-
ments are only to be carried out by an
authorised specialist. The valid local and
national regulations must be observed. This
applies especially to burners, ignition, safety
and control elements.
replacement are only to be replaced by origi-
nal spare parts. Periodic tests for gas leaks
must be carried out. A service contract is
therefore recommended.
Cleaning and maintenance must be done
only when the heating surfaces are cold. Do
not use inflammable liquids to clean the
appliance.
An obligatory service check is required
annually.
Page 4
GENERAL INFORMATION
Parts requiring
2. TECHNICAL DATADATA
PNC Appli-
Appliance type
ances
9CHG584158 WLGWAFOOOO
9CHG584160 WLGWAAOOOO
9CHG584162 WLGWACOOOO
9CHG584161 WLGWDAOOOO
9CHG584163 WLGWDCOOOO
9CHG584159 WLGWDFOOOO
3. GAS CONSUMPTION
Power BTU
kW
15.2 52000
22.8 78000
4. PACKAGING
All the packaging materials used are environmentally friendly.
They may burnt at an incineration plant or sent for recycling.
5. TESTS / CERTIFICATES
All gas appliances are tested according to the standard ANSI
Z83.11-2002 and CSA 1.8-2002 of Gas Food Service Equip-
ment.
6. SPECIFICATION PLATE
The specification plate (E) is located in each case inside and
outside on the right of the operator panel (C) (Fig. 5).
The serial number is marked on the type plate. The 8 digits
give following information:
Y last digit of the year of production
WW week of production
XXXXX running number
Width Cooking
Depth surface Burner
Height
inch mm Power in kW
840 x 740
27.6 700
mm
35.4 900 15.2
33.1" x
35.4 900
29.1"
62.9534.01_UL
Gas
oven
7.6