Technical Information - Electrolux EQT4520BOG Notice D'utilisation

9. TECHNICAL INFORMATION

Serie EQT4520BOG
Typ 55 TEP 02 AO
4. Loosely screw the fixing plates into
the appropriate holes in the protec-
tive casing.
5. Put the first appliance in the worktop
cut out. Put the connection bar in the
worktop cut out and push up half of
the width against the appliance.
6. Loosely turn in fixing plates from be-
low on the worktop and on the con-
nection bar.
7. Put the subsequent appliance in the
worktop cut out . Make sure that the
front ends of the appliances are on
the same level.
8. Tighten the fixing plate / retaining grip
screws.
9. Seal the gap between the worktop
and appliances and between applian-
ces with silicone.
10.
Put some soapy water on the silicon.
11. Press the rubber shape with some
strength against the glass ceramic
and move it slowly along the space.
12. Do not touch the silicon until it be-
come hard, it can last about a day.
13.
Carefully remove silicon that came
out with a shaving blade.
14.
Clean glass ceramic fully.
Prod.Nr. 941 460 009 01
220-240 V 50-60 Hz
ENGLISH 35