General Information; Regulations And Standards - Electrolux HSG Panini Manuel D'utilisation

2-4 LOCATION AND LAYOUT
!Always, place the appliance on a strong, fl at, stable support.

GENERAL INFORMATION

• The appliance must be installed over a counter top.
• The installation of the appliance must be with a silicone rod all
around it. (see picture below).
• The installation diagrams gives the overall dimensions of the
appliances and its position in space See
• The presentation diagram describes and locates each part of
the appliance. See
A. Lid
B. Handle
C. Control panel
D. Feet
E. Ventilation holes
F. Front top cover
G. Steam evacuation chamber
H. Upper heating plate and its locking system
I. Glass
J. Electro magnet
K. Cooking chamber
• The appliances are not designed for built-in installation. See
for minimal space required.
• Maintain an adequate distance between the appliance and
any combustible walls .
• Leave an adequate space between the appliance and any
side walls in order to allow subsequent servicing or maintenance
operations and its proper ventilation . See
• After the installation of the appliance, remove the screw that
gets the handle closed : this screw is on the right side of the
latching system.
• Before starting to use the appliance, check its perfect levelness
with a level.

2-5 REGULATIONS AND STANDARDS

Important!
The technological systems and appliance must be installed
by qualifi ed personnel authorized to issue the certifi cates of
conformity and compliance with current regulations.
2-6 BUILDINGS AND WORKPLACES
All the laws, regulations and directives in force in the place of
installation regarding the following must be observed:
- Correct lighting of workplaces -
- Safety in the workplace, accident prevention
- Compulsory signs and signals
HSG GB 06 2009
5
1
5
Important!
Do not obstruct the vent holes of the appliance in any way
• Before plugging the appliance in, check:
- the compatibility of the plug in the country of use
- that the main switch, the power supply voltage and operating
frequency are suitable for the load of the appliance according
to the data plate
- Check the conformity of the electrical system with current
standards and ensure that the prescribed protection and sa-
fety devices are installed. The appliance must have a ground
connection in conformity with current standards. Carry out
the equipotential connection, in appliances where required, by
means of the special terminals marked with the symbol:
- check the compatibility of the data plate specifi cations with
the mains voltage and frequency.
Information on sound emissions: The functional components
of the appliances in question have a noise level not exceeding
70 dB (A).
Important!
Make sure that the plug of the appliance is reachable in any
2
working conditions.
WARNING!
Do not locate appliance adjacent to any high heat or grease
producing piece of appliance, such as a range top, griddle,
fryer, etc., that could allow radiant heat to raise the exterior
temperature of the appliance.
WARNING!
Do not use reducers, adapters or branches for the connection,
as they could cause false contacts with risk of dangerous
overheating.
Important!
The manufacturer declines any responsibility for damage or injury
due to incorrect installation of the appliance.
Place or locate this appliance in a well-lit area
Warning!
Improper installation or modifi cations can cause damage or
Death.
Do not place and use this appliance in an explosive atmos-
phere
Important : The installation instructions contained herein
are for the use qualifi ed installation and service personnel.
Installation or service by other than qualifi ed personnel
may result in damage to the appliance and/or injury to the
operator.
FAILURE TO COMPLY WITH INSTALLATION INSTRUCTION
OR IMPROPER INSTALLATION WILL VOID WARRANTY AND
RESPONSIBLITIES OF THE MANUFACTURE.
- Hygiene
- Work zones and separation of paths for hygienic purposes
- Fire prevention
- Low air pollution emissions.
4/11