Fuel Cap / Fuel Filter - Gardeo GSTD26ROOF Traduction Des Instructions Originales

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. Conserve water by using power blowers instead of hoses for many lawn and garden applications, including
areas such as gutters, screens, patios, grills, porches and gardens.
11. Use intermediate tube plus nozzle of your choice so the air stream can work close to the ground.
12. After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles.
5.6 OPERATION INSTRUCTIONS
1. Follow the instructions "STARTING A COLD ENGINE".
2. once unit is running, place unit on your back by slipping arms through the shoulder straps as if your were putting
on a jacket
3. When preparing to clear an area of debris, always position yourself so that you can control the direction debris
will be blown.
4. The control handle and the flexibility of the blower tube assembly will allow you to clear the most hard–to-reach
areas.
5. The hand grip ,throttle trigger, throttle lock and ignition on/off switch(B)are all mounted on a swivel handle that
offers a wide range of operating positions and comfort
6. MAINTENANCE
6.1AIR FILTER
CAUTION: NEVER operate blower without the air filter or dust and dirt will be sucked into the engine and
damage it. The air filter must be kept clean. If it becomes damaged, install a new filter.
TO Clean Air Filter:
1. Loosen knob(A) holding air filter cover in
place, remove, cover(B)and lift filter(C)from
air box (Fig.17&Fig.18).
2. Wash filter in soap and water. DO NOT USE
GASOLINE!
3. Air dry filter.
4. Reinstall air filter and air filter cover.
NOTE: Replace filter if frayed, torn, damaged or unable to be cleaned.

6.2 FUEL CAP / FUEL FILTER

CAUTION: Remove fuel from unit and store in approved container before starting this procedure. Open
fuel cap slowly to release any pressure which may have formed in fuel tank
NOTE: Keep vent(A)on fuel cap clean of debris(Fig.19).
Fuel filter.
1. Completely remove fuel cap from fuel tank(B) to be able to remove fuel filter(C) from tank. Use a piece of wire(C)
with a hook formed at the end to pull filter out of tank.(Fig.20)
2. Pull off fuel filter(C) with a twisting motion.(Fig.21)
3. Replace fuel filter.(Fig.21)
NOTE: Never operate the blower without the fuel filter. Internal engine damage could result!
Fig.19
Fig.17
Fig.20
Fig.18
Fig.21

Publicité

Table des Matières
loading

Table des Matières