Important Idling Information; Stopping The Engine; Blower Operations - Gardeo GSTD26ROOF Traduction Des Instructions Originales

5.2 IMPORTANT IDLING INFORMATION

In some cases due to operating conditions(altitude, temperature etc.)your blower may
need a slight adjustment to the idle speed. After warm up, if unit does not Idle after
restarting 2 times ,follow these steps to adjust idle.
1. Locate the idle adjustment screw(G)on the carburetor(Fig.15).
2. Using a Phillips or slotted screwdriver-turn screw 1/4 to 1/2 turn clockwise(to
the right).Unit should then idle properly.

5.3 STOPPING THE ENGINE

5.3.1 Emergency STOPPING Procedure
When it is necessary to stop blower engine immediately, PRESS the OFF"STOP "
switch(A).(Fig.16)
5.3.2 Normal Stopping Method.
For normal stopping, release trigger and allow engine to return to idle speed. Then
PRESS the OFF "STOP
5.4 STARTING A WARM ENGINE(Engine has been stopped for no more than 15-20minutes)
1. Set throttle latch (see step 2 for starting a cold engine),pull starter rope briskly.
2. If engine does not start, or starts and then stops after 5 rope pulls, follow procedure "STARTING A
COLD-engine".

5.5 BLOWER OPERATIONS

1. Use the blower for trees, shrubs, flower beds, and hard-to-clean areas.
2. Use the unit around buildings and for other normal cleaning procedures.
3. Use the blower around walls, overhangs, fences, and screens.
WARNING: Because of flying debris, always,
Approved shielded safety glassed or face
Shield when operating blower.
WARNING: Before using your blower, review
Safety Precautions in your user Manual, and
all regulations for operation of the unit.
These precautions and regulations are for your
Protection.
4. We recommend that a face mask be worn when operating blower in dusty areas.
5. Stand away from the debris, at a distance that will easily allow you to control the direction of blown debris. Never
blow debris in direction of bystanders.
6. To control velocity of air stream, blower can be operated at any speed between idle and full throttle.
experience with the unit will help you determine the amount of airflow necessary for each application.
7. To reduce sound levels, limit the number of pieces of equipment used at any one time .
8. Check your equipment before operation, especially the muffler, air intakes and air filters.
9. Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when
water is available.
"switch(A).(Fig.16)
WARNING: DO NOT operate the blower
other people or animals in the immediate
Vicinity. Allow a minimum of 50
feet(15 meters)between operator and
other people or animals.
Fig.15
Fig.16