Error Indications - Citizen CT-S4500 Mode D'emploi

4.5 Error Indications

 Paper end, paper near-end
The end of paper is detected in two stages, paper near-end and paper end.
For paper near-end, the status LED lights amber. Prepare to replace the paper.
For paper end, the status LED lights red and the buzzer sounds. Load a new paper
roll. The buzzer may not sound depending on the memory switch setting.
 Cover open
If the cover is opened, the status LED lights red.
The buzzer may sound depending on the memory switch setting.
Do not open the cover during printing. If the cover is accidentally opened, the status
LED flashes in red and the buzzer sounds. Check the paper, pull it straight out of
the printer by a couple of centimeters, and then close the cover. Printing restarts. A
command must be sent to restart printing depending on the memory switch setting.
 Cutter error
If the auto cutter stops due to paper jamming, etc., the status LED flashes in red
and the buzzer sounds. Remove the cause and press the FEED key. If the auto
cutter still does not move and the paper cover cannot be opened, refer to "Clearing
a Cutter Error."
 Print Head Hot
Dense printing, heavy black printing, and continuous printing in a high temperature
environment increase the temperature of the print head. When the print head
exceeds a certain temperature, the printer stops printing and waits until the
temperature of the print head decreases. At this time, the status LED flashes in red.
When the temperature decreases, printing restarts automatically.
Refer to 4.2 Clearing a Cutter Error
68
— —