Error Indications - Citizen CT-E651 Mode D'emploi

4.5 Error Indications

 Paper end, paper near-end
The end of the roll of paper is detected at two stages, paper near-end and
paperend.
When paper near-end is detected, the PAPER LED flashes. Prepare a new paper
roll.
When paper end is detected, the PAPER LED lights and the buzzer sounds. Load a
new paper roll. Memory switch settings can be used to disable the buzzer.
 Cover Open
If the cover is opened, the CUTTER LED lights and a buzzer sounds. The buzzer
may not sound depending on the memory switch setting. Do not open the cover
during printing. If the cover is accidentally opened, the CUTTER LED flashes.
Check the paper, pull it straight out of the printer by a couple of centimeters, and
then close the cover. Printing restarts. A command must be sent to restart printing
depending on the memory switch setting.
 Cutter error
If the auto cutter cannot move because of a paper jam or something else, the
CUTTER LED flashes and the buzzer sounds. Remove the cause of the trouble and
press the FEED button. If the auto cutter still does not move and the paper cover
cannot be opened, refer to "Clearing a Cutter Error."
 Print head hot
When you print dense characters, dark images, or for an extended time in a hot
environment, the print head temperature increases. If the print head exceeds a
specified temperature, the printer stops printing and waits for the print head to
cool. When this happens, the PAPER LED, CUTTER LED, and COVER LED flash.
Printing resumes automatically when the print head cools.
 Black mark/label gap detection error
The black mark or label gap cannot be detected.
The PAPER LED flashes and a buzzer sounds.
Adjust to black mark sensor or the label sensor with the paper you are using.
Refer to 4.2 Clearing a Cutter Error
Refer to 3.12 Calibrating the Paper Sensor
60
— —