Teac CR-H700DAB Mode D'emploi page 59

7 Click Upload.
If the following message appears, click OK, and then
return to Step again.
5
8 Click OK to start the firmware update.
When the update starts, the following message
appears.
o The update status is also displayed on the unit.
CAUTION
o If the following window is displayed on the screen
during the update process, the unit's firmware is being
updated. Please wait.
o During the update process, do not turn off the power
of the CR-H700DAB, the computer or any network
peripherals (access point, router, splitter, repeater,
etc.) involved in the data transmission and do not
disconnect their power plugs.
WARNING
Unplugging the mains cord as well as power outage
may interrupt the update process and may result in
permanent damage to the unit.
o If the following message appears, do not click OK until
the unit restarts.
If you click OK by mistake before the unit restarts, the
webpage will not appear.
o When the firmware update is completed, the unit will
restart automatically.
59