User Safety Precautions - PERFECTPRO ROCKHART Mode D'emploi

Speakers
18
Multimedia compartment fixture
19
Aux in 2 socket
20
USB charging socket
21
FM rubber antenna
22
DC IN socket
23
Power cord
24
25 Socket for software upgrade
26 Battery compartment
27 Display protection bar
NFC detection tag
28
Display
A RDS indicator
Battery power
B
EQ indicator
C
Loudness On
D
Stereo indicator
E
Two Line text display
F
Safety information for the internal
rechargeable Lithium-ion battery
The internal rechargeable lithium-ion battery used in
this device is able to supply power for a long period of
time. However, even lithium-ion batteries reach a point
where they cannot be recharged. If the battery does
not recharge after several attempts, it may be drained
(has a low charge), please contact Perfectpro for repair
information. However, if you do not want us to replace the
battery, you will need to dispose of used batteries / device
in accordance to the laws and regulations in your area. In
addition, you can contact your local electronics retailers or
recycling center for disposal.

User Safety Precautions

● Ensure that the room temperature range is 5°C–40°C
(41°-104°Fahrenheit) before charging the battery.
● Do not attempt to disassemble the plastic covering or
any parts of the device, as the materials inside may be
toxic and may damage skin and clothes.
● Do not puncture, crush, modify, throw or cause any
unnecessary shock to your battery, as the battery used
in this device may present a risk of fire, explosion, or
chemical burn if mistreated.
● Do not leave, charge or use the battery in a car under
direct sunlight, near fire or a heated source.
● Do not immerse or throw the battery in water / seawater.
● Do not use or charge the battery if it appears to be
abnormally hot, discolored, deformed or abnormal
conditions are detected during use, charge or storage.
● Do not leave a charging battery unattended. Keep the
battery away from babies and children.
● CAUTION: 'Risk of explosion if the battery is replaced
by an incorrect type.'
● CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
● The battery combination is stored at room temperature
(25 degrees), charged to 40%~60% of the power, charge
once every three months, for the storage of more than a
year of battery, performance cannot be guaranteed.
AC operation / Charging the radio
The radio can be charged both while the radio is powered
on and powered off. Before you plug the AC cord into the
AC socket, be sure the voltage is correct. Connect the
AC power cord into the AC socket to charge the built-in
lithium-ion battery. AC cable hook is designed to store the
cord when the radio is not in use.
When the charge LED indicator lights red indicating
battery is charging. The battery will be fully charged in
around 7 hours when the radio is in power off mode. The
charging time may vary when the radio is turned on or off.
When charging is complete, the charge LED indicator will
be steady green.
When charging is abnormal, the charge LED indicator
will cycle between red and green. Please remove the AC
power and plug it in again.
IMPORTANT
The mains plug is used as the means of connecting the
radio to the mains supply. The mains socket used for
the radio must remain accessible during normal use. In
order to disconnect the radio from the mains completely,
the mains plug should be removed from the mains outlet
completely.
Powered via DC IN socket
The radio can be also powered via the DC IN socket
which can allow 12 Volt DC, which is designed to be
powered by the vehicle or the boat so you can take the
radio with you outdoors or on the boat.
An additional cigarette lighter cable is required (supplied)
for this device.
NOTE
Never use the 12 Volt socket in rainy or moist conditions
to prevent moist from entering the radio. Always keep
the rubber cover on the back well closed under these
conditions.
NOTE
The voltage of DC in socket must be higher than the
13.5V input voltage to ensure that the lithium-ion battery
is fully charged. If the voltage is too low, the battery
cannot be fully charged. It is recommended to use the
AC power cord for charging.
Automatically updating the clock
1.
Press the Standby button to switch on your radio.
2.
Press and hold the Menu button until the Advanced
menu of the current mode shows on the display.
3.
Rotate the Tuning control until 'System' appears on the
display. Press the Tuning control to enter the setting menu.
4.
Rotate the Tuning control until 'Time' appears on the
display. Press the Tuning control to enter the setting menu.
GB
NL
D
F
3