This Must Be Considered During Installation - Weka 126 Gr.1 Notice De Montage, D'utilisation Et D'entretien

In order to avoid wind damage, anchor the floor beams of the cabin to the foundation. Concrete anchors or steel
angles and heavy-duty dowels available from specialist dealers are suitable for this. The anchors are not
included in the scope of this delivery.

4.5. This must be considered during installation!

At least two people are required to assemble the log cabin.
Please drill pilot holes for all screw connections to avoid damaging the wood. The following symbol in the
instructions will indicate when this is necessary:
The pallet on which the cabin is transported comprises two floor beams which are to be used in the assembly of
the cabin.
The intermediate spaces between the floor beams guarantee the necessary subfloor ventilation for the house.
Fit the wall boards together, with the tongue pointing upwards. If necessary, use a rubber mallet. The assembly
timber will prevent any damage to the tongue. The assembly timber can be found in the cabin's front wall pack.
In order to check the right angles, measure the diagonals and make any necessary corrections until you have
the same values.
The wall boards are laterally interchangeable. If the cabin has an off-centre door opening, you can fit the door in
the left or in the right half of the front wall. The door will always open to the right.
With an asymmetrical roof, the door must be located under the gable peak in order to ensure that it opens fully
with no problems.
The gap between the upper edge of the door frame and the wall board is intentional. In contrast to the door
frame, the wall boards undergo a settling process over time which makes this gap necessary as an expansion
zone. The cover battens attached to the door frame (under no circumstances to the wall boards) ensure a clean
transition from door frame to the wall boards.
The roofing felt provided serves primarily as a temporary protection against the weather. TO ensure lasting
protection we recommend you to cover the roof only with sanded bitumen shingles. This creates the basis for a
long life and resistance to the influences of the weather. Otherwise damage to your weka product is to be
expected.
If you have decided to cover your house with bitumen tiles, we recommend that they are laid directly on
the roof boards.
Make sure you remove the film on the bitumen strips before laying!
If cabins have wind bracing in the form of threaded bolts, the threaded bolts are only mounted hand-tight,
i.e. the spiral springs may not be under complete tension.
Ensure that with such cabins no rigid connections of the individual wall boards occur beneath each other, e.g.
by installing a shelf, a gutter downpipe or similar, so that these can work unhindered!
The functional efficiency of the wind anchorage is to be inspected twice a year.
The possibility of differing wood moisture and tolerances in individual components may lead to variations in
dimensions, particularly in the area of the pediment/side wall height, which must be adjusted by appropriate
means (e.g. electric planer) during assembly.
The window and door panes are to be sealed all round directly after assembly and following successful
treatment with transparent silicone for window construction to guarantee complete resistance to driving rain. The
silicone is not included in the scope of delivery.
If this is not done, extreme levels of precipitation may cause moisture inside the cabin, resulting in colour
changes and damage to the wood. The manufacturer accepts no liability for such damage which shall neither be
eligible for compensation within the scope of the warranty nor covered by the manufacturer's guarantee. In this
respect, express reference is once again made to our warranty conditions at this point.
 Copyright HRB 3662
Techn. Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
12