Remote Commands - sylvac ISP091201D Mode D'emploi

16. Remote commands

The data request is done by the sending of the character ASCII <?>, followed by <CR> (carriage return). The instru-
ment also answers in the same way during the detection of an impulse pedals/automat.
The other commands are shown in the following table:
AOFF 0 / AOFF 1
AOFF?
BAT?
ID ?
IN
KEY?
KEY 0 / KEY 1
ECO 1 / ECO 0
ECO?
LCAL?
LCAL DD.MM.[YY]YY
MM
Deactivates/activates the automatic switch-off
Forwards the state of the automatic switch-off
Sends the status of the battery (BAT1=ok or BAT0=low)
Sends the instrument identification (SY276)
Activates the Inch unit
Sends keyboard status (KEY0 or KEY1)
Locks/unlocks the keyboard (except data output)
Activate/de-activate economic mode
Current economic mode
Sends the date of the last calibration (DD.MM.YYYY)
Sets the date of the last calibration
Activates the millimeter unit
21
E