IMG STAGELINE DPR-3000 Mode D'emploi page 27

2) Check the signal source (f) indicated and change it, if necessary
( chapter 7.3.1). If internal microphones (MIC 90, MIC 180, MIC 360)
have been selected as a signal source, the LED (2) or the LED (26)
flashes or both flash. Thus, the selected recording direction is shown
at the same time.
3) Check the memory location for the recording (a) as shown and change
it, if necessary (
4) Check the recording quality as shown and change it, if necessary.
The display shows the recording format (c) and the corresponding
sampling rate or data rate (b). To change these adjustments
ters 7.3.3 to 7.3.5.
5) Check if the recording time available (i) will be sufficient. It is calculated
from the free capacity of the memory location selected and the record-
ing quality selected. If the time indicated is too short, it may be in-
creased by selecting a larger storage medium or by decreasing the
recording quality.
6) The level of the input signal is shown as bar graphs (j). Adjust the am-
plification with the button
marking "0" at the right edge with passages of high volume.
In addition, for a microphone recording, adjust the sensitivity with
the sliding switch GAIN (6):
H = high sensitivity
M = medium sensitivity
L = low sensitivity
7) Start the recording with the button
play, REC (d) is shown now and the LEDs (2, 26) flashing previously
now light up continuously. The display shows the time of the current
recording (h) up to now.
To exit the recording on stand-by without starting a recording, press
the button ⁄
8) To pause the recording and to continue the recording subsequently in
the same file, press the button
9) To finish the recording, press the button
display (d)
⁄ .
The last recording made can be replayed via the button
To replay the other audio files
At the selected memory location the recorder creates a folder with the
name DPR-REC in which all audio files are memorized during recording.
Depending on the selected recording format, the files are named as
"DPR-xxxx.MP3" or "DPR-xxxx.WAV" (xxxx = consecutive number). The
current name (g) is shown on the display. If there is not enough free mem-
ory at the selected memory location, the message "Not enough disk
space!!" is shown when starting the recording.
chapter 7.3.2).
or
(12).
is shown. To start a new recording, press the button
(15) so that the bars hardly reach the
⁄ (18). On the top right of the dis-
⁄ in each case.
(10). On the top right of the
chapter 6.
GB
chap -
⁄ (12).
27