Setting Up The Recorder; Placing The Windshield; Switching The Recorder On And Off; Recording - IMG STAGELINE DPR-3000 Mode D'emploi

4.6 Setting up the recorder

GB
To set up the recorder, tightly screw the supplied base to the threaded
jack (21) on the lower side or mount the recorder e. g. on a stand with
6.35 mm (¼") thread.

4.7 Placing the windshield

To talk into the built-in microphones (e. g. for an interview) or to record
wind instruments at close range, place the supplied foam windshield on
the upper part of the recorder so that the microphones (1 and 25) are cov-
ered.

4.8 Switching the recorder on and off

To switch on the recorder, set the POWER switch (7) to position ON. After
a few seconds the display (3) shortly shows the start screen and then
changes to the display for the reproduction (
remains dark after switching on or if the symbol
at the bottom of the display, the batteries are exhausted and have to be
replaced (
Switch off the recorder after use with the POWER switch (position OFF).
A current recording must always be terminated prior to switching off [but-
ton (10)], otherwise data loss may occur.

5 Recording

1) Press the button
by.
Information shown on the display (3) during recording:
a Storage medium:
SD, USB or FLASH
b Data rate in case of MP3 format
or sampling rate in case of WAV
format
c Format: WAV 16 bits, WAV 24 bits
or MP3
d Recording status:
REC current recording
e Name of directory
f Signal source: MIC 90, MIC 180,
MIC 360, Line in, EXT. MIC mono
or EXT. MIC stereo
g Symbol for the recording mode
h Recording time elapsed of the current recording
i Remaining recording time, depending on the capacity of the data
memory used and the recording quality selected (999 h max. are
shown)
j Signal level display for the output of the left "L" stereo channel and the
right "R" stereo channel
k Present time
l Battery status:
When supplied with power via the mini USB jack (22):
When charging the batteries via the mini USB jack:
26
chapter 4.5.1).
⁄ (18) to set the recorder to recording on stand-
appears on the top right of the display (d).
pause of recording
recording finished
full
and file name
→ → →
discharged
chapter 6). If the display
is shown on the right
(flashing)