Maintenance And Service - Scheppach kw 7.0 Traduction Des Instructions D'origine

m Attention! Emergency stop only for Cardan shaft operation (Fig. 3-4)
Fig.3
Fig. 4
1
End of work
• Switch off the drive on the On/Off switch or tractor.
• Wait until the blade has completely stopped.
• Unplug the mains plug or ignition key.
• Observe general maintenance instructions.
• Place the jack in the transport position and secure it with the locking lever.

16. Maintenance and service

m Perform maintenance, modification, adjustment and cleaning work only with the engine switched off and the
mains plug or spark plug connector is unplugged.
• Keep the manual at the machine.
• Keep machine clean.
• Wear protective goggles when cleaning.
Before undertaking any maintenance or checking work, the working area must be cleaned. Keep the necessary tools
within the reach of your hand.
The intervals mentioned herein are based on normal conditions of use. An excessive use of the machine shortens the
intervals accordingly.
Clean the panels, screens and control levers with a soft cloth. The cloth should be dry or slightly humid with a neutral
cleaning agent. Do not use any solvents like alcohol or benzene as they could damage the surfaces.
Keep oils and lubricants out of reach of unauthorised persons. Read through the instructions on the containers carefully
and follow them closely. Avoid direct contact with the skin and wash off thoroughly after use.
Check the V-belt tension after the first hour of operation and every time before starting up. To do so, undo the T-screw on
the motor bracket. Press the bracket down and tighten the T-screw again.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
In case of danger in Cardan shaft operation, release the emer-
gency stop lever (1) lightly to the left and slide down. This stops
the saw blade and the Cardan shaft runs on. Then switch off the
Cardan shaft on the tractor immediately! (Otherwise very high
wear on the drive!)
1
Attention! Do not use the emergency stop to switch off the saw
in normal operation. (Otherwise very high wear on the drive!)
GB 31