Publicité
Les langues disponibles
Les langues disponibles
Start by inserting two stainless socket-head cap screws through the lower mounting bracket, through the
enclosure mounting holes, and into the threaded mounting plate. Leave these screws loose for the moment.
Attach the enclosure to your mounting bar using the upper mounting bracket and two more stainless socket-
head cap screws. While still loosely assembled, visually align your KM Tower Enclosures to the desired angle.
Using tape, a pencil, or some other means, mark the mounting angle of the mounting bracket bottom in relation
to the KM Tower Enclosure(s). Remove the enclosures and then do fi nal tightening of the lower mounting
bracket to the enclosure, aligning it with the marks you made. Once your fi nal adjustments are made do not use
excessive force to further aim the enclosures. If your aim is off, remove the KM Tower Enclosures and loosen the
screws between the enclosure and the lower mounting bracket, then reset the angle.
ABS mounting inserts
Loosely fi ll the enclosure with poly-fi l, the
white protective layer in the packaging.
The KMTED will use one full sheet,
whereas the KMTES will use one sheet for
a woofer and one-half sheet for a horn.
mount speaker to enclosure
(recommend M4 or #8 screws)
2012 KM Towers Rev F.indd 3
2012 KM Towers Rev F.indd 3
remove inner screws
from back of enclosure to
orient back plate.
stainless steel socket-
head cap screws (1/4"
Allen wrench)
upper mounting bracket
lower mounting bracket
(set desired angle before
completing mounting)
attach wiring to outer
terminals
attach soldered wiring from inner
terminals to speaker terminals, keeping
in mind the polarity of each.
3
11/4/2011 10:23:53 AM
11/4/2011 10:23:53 AM
Publicité
