Setup; Display Setup Operation - Alpine TME-M740BT Mode D'emploi

Setup

You can flexibly customize the unit to suit your own preferences and
usage.
Use steps 1 to 4 to select one of the SETUP modes to modify. See
the applicable section below for details about the selected
SETUP item.
1
Touch [SETUP] on the source select screen.
The SETUP selection screen is displayed.
2
Touch the desired setup item.
DISPLAY
DIMMER/DIMMER HIGH/DIMMER LOW/CALLING DISPLAY/
DISPLAY MODE/SCREEN ALIGNMENT/VISUAL EQ
GENERAL
BEEP/LED BRIGHTNESS/VOLUME CONTROL
SYSTEM
INT MUTE/AUX NAME/NAV. MODE/CAMERA INT
Bluetooth
Bluetooth/ SEARCH DEVICE/ACTIVE DEVICE/PAIRED DEVICE/
AUTO CONNECT/VISIABLE MODE/AUTO ANSWER/REFUSED
CALL/PHONEBOOK/MIC GAIN
REAR SELECT
REAR SELECT
3
Touch [ ] or [ ], etc., of the desired item to
change its setting.
Switch page
Returns to the previous display.
Change the setting item.
Displays the detailed setting screen.
Exits the setting screen.
4
Touch [EXIT].
10
-EN

Display Setup Operation

Setting the Brightness of the Backlighting (DIMMER)
HIGH / LOW / AUTO (Initial Setting)
Backlighting is provided by a fluorescent light built into the liquid
crystal panel. The illumination control adjusts the brightness of
the backlighting based on the car ambient lighting for easier
viewing.
HIGH: Sets the brightness of the screen to the same brightness that
was set in DIMMER HIGH in "Adjusting the Maximum Level of
Backlight (DIMMER HIGH)" (page 10).
LOW: Sets the brightness of the screen to the same brightness that
was set in DIMMER LOW in "Adjusting the Minimum Level of
Backlight (DIMMER LOW)" (page 10).
AUTO: Adjust the brightness of the background illumination of the
monitor automatically to the brightness of the car interior.
Adjusting the Maximum Level of Backlight
(DIMMER HIGH)
MIN(16) to MAX(31) (Initial Setting: MIN)
If HIGH is set in "Setting the Brightness of the Backlighting
(DIMMER)" (page 10), you can adjust the brightness of the
backlighting. This function can be used, for instance, to change
the screen brightness while traveling at night.
Adjusting the Minimum Level of Backlight
(DIMMER LOW)
MIN(0) to MAX(15) (Initial Setting: MIN)
If LOW is set in "Setting the Brightness of the Backlighting
(DIMMER)" (page 10), you can adjust the brightness of the
backlighting. This function can be used, for instance, to change
the screen brightness while traveling at night.
Setting the Screen to be Displayed while Calling
(CALLING DISPLAY)
TEL.(Initial Setting) / MAIN
While a call is placed by a hands-free phone, you can set
whether the telephone screen or the navigation screen, etc., is
displayed
TEL.: Displays the telephone screen.
MAIN: Displays the current source screen (navigation, etc.).
DISPLAY MODE
WIDE (Initial Setting) / CINEMA / NORMAL
WIDE: The monitor displays a normal picture wider to fit in a
wide-screen monitor by evenly stretching out the picture
horizontally.
WIDE