Connections - Alpine TME-M740BT Mode D'emploi

Connections

18
-EN
AUX IN (White)
AUX IN (Red)
AUX IN (Yellow)
AUX OUT (White)
AUX OUT (Red)
AUX OUT (Yellow)
CAMERA IN (Yellow)
OUT INT
(Pink/Black)
REMOTE OUT (AUX IN)
(White/Brown)
M. CONT
(White/Pink)
REVERSE
(Orange/White)
PARKING/HAND BRAKE
(Yellow/Blue)
FOOT BRAKE
(Yellow/Black)
ACC
(Red)
FUSE
(2A)
GND
(Black)
Audio Input Connector (AUX IN) (White)
Left input the audio.
Audio Input Connector (AUX IN) (Red)
Right input the audio.
Video Input Connector (AUX IN) (Yellow)
Input the video.
Audio Output Connector (AUX OUT) (White)
Left output the audio.
Audio Output Connector (AUX OUT) (Red)
Right output the audio.
Video Output Connector (AUX OUT) (Yellow)
Output the video.
Camera Input Connector (Yellow)
Use when connecting a back-up camera.
Audio Interrupt Out Lead (Pink/Black)
Remote Control Output Lead (AUX IN) (White/Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Monitor Control Lead (White/Pink)
Connect this to the Monitor Control Lead of a touch panel
compatible product.
Reverse Lead (Orange/White)
Use only when a back-up camera is connected. Connect to
the plus side of the car's reverse lamp that lights when the
transmission is shifted into reverse (R).
Switches the video picture to the back-up camera. This is
linked with putting the car into reverse (R).
Parking/Hand Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the TME-M740BT.
Foot Brake Lead (Yellow/Black)
Connect to the vehicle's foot brake lead or brake lamp lead.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory
position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
RGB Input Connector
Connect this to the RGB output terminal of the Navigation
System or Vehiclehub Pro System.
Main monitor
Display cable / Power cable
Fuse Holder (2A)