System Setup; Bluetooth Setup - Alpine TME-M740BT Mode D'emploi

SYSTEM Setup

Hands-Free Phone Interruption Setting (INT MUTE)
ON (Initial Setting) / OFF
You can set a hands-free phone call to interrupt the head unit
(DVA-9861, etc.).
ON: The received call or placed call interrupts the head unit. Audio
of the head unit is muted at this time.
OFF: The received call or placed call does not interrupt the head unit.
• IN-INT cable connected devices should be connected to the OUT-INT
cable of the unit.
* To make voice interruption of the mobile phone to the head unit,
perform the following setting at the same time. If the settings are not
performed, voice cannot be interrupted to the unit.
Set to ON in "Making effective use of Refused Call (REFUSED
CALL)" (page 13) and Bluetooth AUDIO in "REAR SELECT Setup"
(page 13).
External Input Name Setting (AUX NAME)
OFF / TV / DVD HU / EXT. DVD / GAME / AUX (Initial Setting)
Select the name from the following list, to be used for the product
using the external input mode. This will apply to the touch switch
name at source selection time and the source name during
playback change.
Setting the Navigation Mode (NAV. MODE)
NAV. (Initial Setting) / EXT. / OFF
OFF: Navigation source is not displayed. The settings related to the
navigation can not be changed from this unit.
NAV.:Navigation source is displayed.
EXT.: The source name is displayed as Vehicle Hub.
Setting of the Rear Camera (CAMERA INT)
ON (Initial Setting) / OFF
When the rear camera is connected, rear pictures are output on
the screen.
OFF: The CAMERA source is not displayed on the SOURCE selection
screen.
ON: Even if the shift lever is not set to reverse (R), the rear pictures
are output by selecting the CAMERA source.
• By shifting to reverse (R), the rear pictures are output. This function
is effective when the reverse wire is properly connected.
12
-EN

Bluetooth Setup

Setting the Bluetooth Connection (Bluetooth)
ON (Initial Setting) / OFF
The setting is made when a hands-free phone or Bluetooth
Audio is used. Be sure to set to ON.
ON: The Bluetooth function can be used.
OFF: The Bluetooth function cannot be used.
Searching for Connectable Bluetooth Device (Bluetooth
Search) (SEARCH DEVICE)
• If [CANCEL] is touched, search of the Bluetooth device is
terminated.
• When a search is complete, a device selection list is displayed. If you
touch [PAIR] of a Bluetooth device to be connected, the pass code
input screen is displayed. Input the same pass code on the screen for
the unit and the Bluetooth device. Refer to "Connect a Mobile
Phone" (page 7).
Observing Bluetooth Device Information (ACTIVE
DEVICE)
You can check the details of a currently connected Bluetooth
device.
• If you connect a mobile phone to another one, be sure to touch
[DISCONNECT], and cancel the currently connected mobile phone.
Setting the registered Bluetooth Device (PAIRED
DEVICE)
Previously up to 8 connected mobile phones to the unit were
registered. Select the one you wish to use.
• If [CONNECT] is touched, the Bluetooth device is connected.
• If [DELETE] is touched, the Bluetooth device is deleted. If [ALL
DELETE] is touched, all Bluetooth devices are deleted.
• If a Bluetooth device which is not registered in the list is connected,
search for a Bluetooth device by touching [SEARCH].