Jenn-Air JF42NXFXDE Guide D'installation page 24

3. Using the installation block as a guide for depth, attach a
shoulder washer with a hex-head pointed screw (both
provided with refrigerator) into the predrilled door panel (2 per
door).
A. Shoulder washer and hex-head pointed screw
B. Installation block
4. For the mounting bracket, insert the hex-head pointed screws
(provided with refrigerator) into the wood holes at the top of
the door panels where they were predrilled.
NOTE: It is critical to use the ⁵⁄₈" screw, the longest length
provided, to attach the bracket to the top of the door panel.
A
A. U-shaped hole
B. Slot
5. Attach a panel top bracket to the top edge of the door panel(s)
by placing the large ends of the keyhole slots over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
B. Panel top bracket
24
A
B
B
B
Drawer Panel
IMPORTANT: This step is complete on Jenn-Air Stainless Steel
Panel Kits.
1. Using the Phillips-head flat screws (provided with refrigerator),
fasten a drawer panel bracket to each side of the drawer
panel, as shown.
A
A. Drawer panel
B. Drawer panel mounting bracket
Top Grille Panel
IMPORTANT: This step is complete on Jenn-Air Stainless Steel
Panel Kits.
1. Using the slotted hex-head screws (provided with refrigerator),
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the "Parts Provided" section to select the
brackets designated for your installation.
Use the Fully Integrated Grille brackets for a fully
integrated grille installation with a full height grille.
Use the standard grille brackets for a Standard Integrated
Grille installation, as shown.
A. Top grille brackets
B. White, grille trim piece
(taped to refrigerator door)
2. Using round-head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim piece in the stainless steel panel kits is
preinstalled on the grille.
B
A
B