Jenn-Air JF42NXFXDE Guide D'installation page 23

2. Using slotted hex-head screws (provided with refrigerator),
attach the top grille vent to the soffit.
A. Top grille vent
B. Slotted hex-head screw
Side View
A. Soffit
B. Airflow
Jenn-Air Stainless Steel Panel Kits (only)
IMPORTANT: The panels included in the panel kits come with the
mounting bracket preinstalled and are prepared for installation.
36" Single Door Models - Door Panel Kit (only)
These panels are designed for refrigerator doors with the hinges
installed on the right-hand side. If you reverse the door swing, you
must move the door panel mounting bracket and the shoulder
washers.
To modify the door panel for a left-hand swing door:
1. Remove the mounting bracket from one end of the door panel
and reinstall it on the opposite end of the panel into the
predrilled holes.
NOTE: The end with the mounting bracket is now the top of
the door panel.
2. Remove the hex-head pointed screws and shoulder washers
from the holes marked with a red "R."
A
B
A
B
C
D
C. Grille panel
D. Door panel
3. Using the installation block as a guide for depth, fasten the
shoulder washers with the hex-head pointed screws into the
predrilled holes marked with a blue "L."
A. Move shoulder washers from Hole R to Hole L.
B. Move mounting bracket.
4. Peel back the film cover on the door panel in the area of the
brackets and shoulder washers only. Do not fully remove the
film covering until the installation is complete.
Custom Wood Panels - Predrill Panels
IMPORTANT: The custom panel template shipped with the
refrigerator can be used for either a ³⁄₈" (0.95 cm) or a ¹⁄₈" (0.32 cm)
reveal installation.
The drilling templates are used only for custom wood overlay
panels.
The drilling templates are double-sided.
The drilling holes are precut into the template.
1. On the template, locate the diagram of your refrigerator. Then,
follow the letters and colored arrows to place correctly the
drilling template on the back side of the panels.
NOTE: Check the direction of the arrows to determine which
holes to mark when the template is aligned at the top of the
panel and which holes to mark when the template is aligned at
the bottom of the panel.
2. Predrill pilot holes into the wood rails bordering the door(s),
drawer and top grille panels.
Custom Wood Panels - Prepare Panels
Door Panel
IMPORTANT: This step is complete on Jenn-Air Stainless Steel
Panel Kits.
1. Place panels on a firm, covered, flat surface with the front
facing down.
2. Locate the 2 predrilled holes in the handle side edge of the
door panel.
A
A
B
23