Troubleshooting Guide; Transmitter And Receiver Binding - Horizon Hobby Losi 22T Twenty Two RTR Manuel D'utilisation

Troubleshooting Guide

Problem Possible Cause
Vehicle does not operate Battery not charged or plugged in
ESC switch not "On"
Transmitter not "On" or low battery
Motor runs but rear wheels Pinion not meshing with spur gear
do not rotate
Pinion spinning on motor shaft
Slipper too loose
Transmission gears stripped
Drive pin broken
Steering does not work Servo plug not in receiver properly
Servo gears or motor damaged
Will not turn one direction Servo gears damaged
Motor does not run Motor wire solder joint is damaged
Motor wire broken
ESC damaged
Sensor wire damaged or loose
ESC gets hot Motor over-geared
Driveline bound up
Poor run time and/or sluggish Battery pack not fully charged
acceleration
Charger not allowing full charge
Slipper slipping too much
Driveline bound up
Poor range and/or glitching Transmitter batteries low
Vehicle battery low
Loose plugs or wires
Slipper will not adjust Drive pin missing in shaft
Slipper plates worn out

Transmitter and Receiver Binding

Binding Procedure
1. Make sure the transmitter and vehicle are both powered off.
2. Install a bind plug in the receiver battery/bind port. You do not need to remove any of the other plugs to re-bind.
3. With the Bind plug installed, turn on the vehicle. Notice a blinking Orange LED within the receiver.
4. With the steering and throttle in the desired preset failsafe positions (neutral), press and hold the bind button and turn on the transmitter.
The red LED on the front of the transmitter will fl ash within a couple seconds, indicating the transmitter is in bind mode. Once the red LED
begins fl ashing, release the bind button.
5. When the receiver binds to the transmitter, the receiver light will turn solid.
6. Power off the vehicle and the transmitter.
7. Disconnect the battery from the ESC. Remove the bind plug from the receiver.
8. Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part loops and clips).
9. The receiver will keep the binding to the transmitter until another binding is done.
If you encounter problems, obey binding instructions and refer to the transmitter troubleshooting guide for other instructions. If needed, contact the
appropriate Horizon Product Support offi ce.
LOSI 1/10 22T 2WD ELECTRIC TRUCK RTR
Solution
Charge battery/plug in
Turn on ESC switch
Turn on/replace batteries
Adjust pinion/spur mesh
Tighten pinion gear setscrew on motor shaft fl at spot
Check and adjust slipper
Replace transmission gears
Check and replace drive pin
Make sure the steering servo plug is connected to
the receiver steering channel, noting proper polarity
Replace or repair servo
Replace or repair servo
Resolder the motor wire with the proper equipment
Repair or replace as needed
Contact Horizon Hobby Product Support
Replace or reinstall sensor wire
Use smaller pinion or larger spur gear
Check wheels and transmission for binding
Recharge battery
Try another charger
Check/adjust slipper
Check wheels, transmission for binding
Check and replace
Recharge battery
Check all wire connections and plugs
Replace drive pin
Replace slipper plates and adjust slipper
EN
7