Use; Charging The Battery Pack; Cleaning; Maintenance And Storage - Parkside PDSLG 20 A1 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
ATTENTION!
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3 .
An up-to-date battery compatibility list can
be found at www .lidl .de/akku .
WARNING!
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or
a similarly qualified person .

Use

Charging the battery pack

CAUTION!
Always unplug the appliance before you
remove a battery pack from or connect a
battery pack to the dual high-speed charger .
NOTE
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C .
If a lithium-ion battery is going to be stored
for an extended period, the charge level must
be checked at regular intervals . The optimum
charge level is between 50% and 80% . The
storage climate should be cool and dry, and
the ambient temperature should be between
0°C and 50°C .
Slide one or two battery packs into the dual
high-speed charger
Insert the power plug into the socket .
The charge level of the respective battery pack is
indicated by the corresponding LEDs
and the adjacent illustrations:
LED 1
flashes: The battery pack is
empty
.
12 
GB │ IE
.
/ /
LED 2
flashes: The battery pack is 1/3
charged .
LED 3
flashes: The battery pack is 2/3
charged .
All LEDs
/ /
battery pack is fully charged .
ATTENTION!
If all of the LEDs
the battery pack has overheated and cannot
be charged .
When charging is complete, disconnect the
dual high-speed charger
and remove the respective battery packs .
You should always switch the dual high-speed
charger
off for at least 15 minutes between
successive charging processes . To do this,
disconnect the power plug from the mains
power socket .

Cleaning

CAUTION!
Always unplug the charger before cleaning it .
Do not clean the charger with water .
Clean the appliance with a dry or slightly
moistened cloth .

Maintenance and storage

If you do not intend to use the appliance for
an extended period, remove the batteries and
store it in a clean, dry place away from direct
sunlight .
If a lithium-ion battery is going to be stored
for an extended period, the charge level must
be checked at regular intervals . The optimum
charge level is between 50% and 80% . The
optimum storage environment is cool and dry .
light up permanently: The
/ /
flash, this means
from the mains
PDSLG 20 A1

Publicité

Table des Matières
loading

Table des Matières