Ryobi EDP-5530L Manuel D'utilisation page 26

GB
F D
SYMBOLS
SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a qualified service technician.
For service we suggest you return the product to your
nearest AUTHORISED SERVICE CENTRE for repair.
When servicing, use only iden ti cal replacement parts.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the op er a tor's manual.
Save this operator 's manual and review
frequently for continuing safe operation and in
struct ing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning power tool op er a tion, always wear
safety goggles or safety glasses with side shields
and a full face shield when needed. We
recommend Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with
side shields. Always use eye protection which is
marked to comply with ANSI Z87.1.
SAVE THESE INSTRUCTIONS.
DESCRIPTION (FIG. 1)
1a. LASER ON/OFF SWITCH
1b. LASER
2. FEED HANDLE
3. DEPTH GAUGE
4. LOCK KNOB
5. TABLE ADJUSTMENT HANDLE
6. BASE
7. TABLE
8. CHUCK
9. DIGITAL DISPLAY
10. POWER SWITCH
11. WORKLIGHT ON/OFF SWITCH
12. WORKLIGHT
13. VARIABLE SPEED LEVER
14. SPINDLE LOCK LEVER
15. SAFETY GUARD
16. TRIGGER
17. SAFETY MICRO SWITCH
E I P NL S DK N FIN
English
FEATURES (FIG. 1)
KNOW YOUR DRILL PRESS (Fig. 1)
Before attempting to use this product, familiarize yourself
with all operating features and safety rules.
BEVEL SCALE
The bevel scale indicates the degree the table is tilted.
CHUCK
Your drill press features a standard three-jaw type chuck
with a self-ejecting chuck key, which prevents
accidentally starting the drill press with the key still
engaged in the chuck.
DEPTH GAUGE
A depth gauge is located between the pulley housing and
feed handles to aid in drilling at desired depths.
DEPTH STOP
The adjustable locking depth stop permits accurate depth
measurement and repetitive drilling.
DIGITAL DISPLAY
Red numbers in the digital display show the RPM of the
tool.
CHUCK TOOL
The chuck tool is used to remove the chuck and chuck
spindle.
EXACTLINE™ LASER
The Exactline™ laser makes accurate, precision drilling
simple and easy.
POWER CORD
The power cord is H05VV-F type with length 1.8 m earthing.
FEED HANDLES
Feed handles raise and lower the chuck and bit during
the drilling operation.
MOTOR
Your drill press is equipped with an industrial duty
induction motor for long-lasting, smooth performance.
SPINDLE LOCK LEVER
The spindle lock lever secures the spindle at the desired
depth for drilling.
SPINDLE SPEED
Five different spindle speeds allow you to drill a wide
variety of material including wood, plastic, and metal.
18
GR H CZ RUS RO PL