AEG IKE64450IB Notice D'utilisation page 17

Problem
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
You can hear a constant
beep noise.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
Possible cause
Power management oper‐
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated. Activate the sounds. Refer to
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
There is an error in the hob.
The electrical connection is
incorrect.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
"Daily use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Re‐
fer to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
17