Laserworld Garden Série Mode D'emploi page 7

6. Installation and operation
1. Choose a suitable indoor or outdoor location for your laser light effect.
2. Installation:
• To attach the laser to the stake, place the rubber washer in between
the angle brackets of the laser and the stake and bolt them together
with the thumb screw that is included in delivery.
3. Connect the psu adapter to the power cable of the device. Connect the
power adapter to mains.
4. Your laser device starts to project immediately.
5. Disconnect the device from mains to switch off the laser light effect.
7. Remote controller operation
Only available for GS-60RG Xmas RC, GS-70GB Xmas RC, GS-70RG move,
GS-100RGB move.
ON / OFF button
Flash increase speed
Rotation increase speed
Only available for GS-100RGB move: For activating all three colors - red, green and
blue - to display at the same time, first select one single color via the remote control.
Then switch off the laser using the red button on the remote controller and switch
it on again. All three colors display at the same time now.
Color change
Rotation decrease speed
Flash decrease speed
Operation mode
Shutdown timer