Mitsubishi Electric Mr.SLIM PEAD-A12AA7 Manuel D'utilisation page 5

■
Remote controller display
* For explanation purposes, all of the items that
appear in the display are shown.
* All items are displayed when the Reset but-
ton is pressed.
Set Temperature buttons
Fan Speed button (Changes fan speed)
Mode button (Changes operation mode)
indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.
received. Signals can be received up to approximately 7 meters, 275-19/32 inch in a direct line
from the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
Consult your dealer for service.
shocks. In addition, do not get the remote controller wet or leave it in a location with high humidity.
a wall and be sure to always place the remote controller in the holder after use.
■
ON/OFF button
Check button
Test Run button
Ref. Pipes
Indoor-Outdoor
Connection wire
Service Panel
Transmission area
Transmission indicator
Timer indicator
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Reset button
1. Remove the top cover, insert 2 AAA batteries,
and then install the top cover.
1
Top cover
2. Press the Reset button.
Power
Earth
2
3
Two AAA batteries
Insert the negative (–)
Install the batteries in the
correct directions
Press the Reset button
narrow end.
5