Rittal Unité E/S CMC III Notice D'installation Et D'utilisation Succincte page 8

Installation and operation, Service
Display of the status change on the multi-LED of the I/O unit:
– Continuous blue flashing: Communication over the CAN bus.
EN
– Green flashing: When the measured value changes or, at the latest, every 5 seconds.
If the installation is not successful: see section 1.1.
Note:
Connection cables in various lengths can be obtained from Rittal.
5.3 Settings
The following parameters can be set or viewed at the CMC III PU web site:
Relay output:
– Value: Current value of the output (0 or 1)
– Delay: Status message delay [s]
– Status: Current status of the associated output taking account of the delay value
Digital input:
– Value: Current value of the input (0 or 1)
– Logic: "Normally open" (0) or "normally closed" (1) selection
– Delay: Status message delay [s]
– Status: Current status of the associated input taking account of the delay value
To determine whether any software updates are required: see www.rittal.com or contact Rittal Service
(see section 6).
6 Service
For technical questions, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
8 Rittal CMC III I/O Unit