Cfm Reduction System; Maintenance - Elica EMD530S3 Guide D'utilisation, D'entretien Et D'installation

CFM Reduction System

Before operating your hood:
Some States and Provinces of the US & Canada restrict the
maximum exhausting airflow of range hoods. Airflow is measured
as cubic feet per minute (CFM). These maximum levels allowed
are detailed in the local code of your area. Please check local
codes to find out if you need to restrict the maximum airflow
of your hood. If your local code mandates a maximum airflow
level below the maximum airflow of this hood (i.e. 600 CFM),
please execute the procedure below to reduce the maximum
airflow.
1
1 Turn the motor OFF.
2 Press the ON/OFF (1) and Intensive speed (5) buttons
together for 3 seconds.
You will hear a beep and all control lights will illuminate
for 3 seconds.
This action will Disable speeds 3 and 4 and effectively
lower the Maximum airflow to > 300 CFM.
3 Locate the CFM certification sticker in the hardware pack.
4
Peel and Affix this sticker to a visible area in the blower.
This sticker provides official certification to your local
inspector that this hoods maximum airflow has been
reduced to > 300 CFM.

Maintenance

Cleaning
Do not spray cleaners directly to the control while cleaning the
Hood. The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the
cloth dampened with neutral liquid detergent. Do not use
abrasive products. DO NOT USE ALCOHOL!
I
WARNING:
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenance
or failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be
set to a low temperature and a short cycle. When washed in
a dishwasher, the grease filter may discolour slightly, but this
does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
A. Spring release handle
5
A
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See "Who to contact" section in the warranty for service
contact information.
Charcoal filter
I
WARNING
To reduce the risk of fire and shock use only the carbon filter kit
KIT02667.
If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filters that help
remove smoke and odors.
1 Cover the grill that protects the suction motor with the
carbon filter so that the slots on the filter correspond to
the pins on the sides of the motor protection grill.
2
Turn the carbon filter clockwise to block them (bayonet
fixing).
NOTE: Remove the wiring to be able of placing the charcoal
filter and then replace it.
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an automatic
dishwasher.
NOTE: Charcoal filters are not included with the hood. They
must be ordered from your supplier. Order the needed kit
specifying your hood model and width size.
11