Télécharger Imprimer la page

Nordelettronica NE185 Instructions D'emploi page 6

Masquer les pouces Voir aussi pour NE185:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB
LEGEND:
F1: 5A fuse connected to the vehicle battery to power the side marker lights
F2: 20A fuse connected to the vehicle battery to power the fridge
F3: 30A fuse connected directly to the service battery to power the Webasto / Auxiliary
F4: 15A fuse connected directly to the service battery to power the step
F5: 15A fuse connected to lights master switch to power the group of lights_1
F6: 15A fuse connected to lights master switch to power the group of lights_2
F7: 10A fuse connected directly to the service battery to turn on the fridge and heater and to the pump
switch to power the water pump
F8: 10A fuse connected directly to the service battery to the courtesy light and external light switch
F9: 15A fuse connected to the AUX switch
Attention:
When replacing faulty fuses, observe the correct amperage.
OPERATION:
Power activated from control panel:
The outputs for internal lights (lights_1 and lights_2), external light, pump and aux are activated
directly by the relevant keys on the control panel.
the relevant keys on the control panel.
-If the service battery voltage remains under 10V for over a minute, the NE185 shunt
automatically turns off all the power for lights, pump. To recharge press the relevant keys on the
control panel. If the battery is still under 10V, it will be deactivated again after one minute.
Services activated by D+:
The coupler relay and fridge relay are enabled immediately in one of these two conditions:
+Alternator
G
JP6 pin1
+12V
The coupler relay recharges the service battery with the alternator when the engine is running.
The fridge relay powers the three-purpose fridge at 12V when the engine is running.
The external light goes out automatically when the engine is running
Side marker signal:
The side-marker output can be activated with a negative control (negative) on the JP13 block, pin 4, or
with a positive control (+12V) on the JP13 block, pin 1.
Car battery recharge:
The coupler relay recharges the starting battery with the charger battery when there is a 230V
mains supply.
The relay is excited when the service battery exceeds 13.5V and automatically drop out when the
230V mains supply is turned off or the service battery voltage is below 12.8V.
WARNING:
If the vehicle not in use and the connection 230V is not present disconnect the battery service with the
battery main switch.
SHUNT NE185_15S
or
+key
KEY-ON
JP13 pin 3
+12V
6
D+
D+
JP13 pin 2
on
GB

Publicité

loading